OpenRFPCloses Nov 24, 2026

Carbide Laser System with ORPHEUS OPA

Department of Energy — SLAC Natl Accel Lab -DOE ContractorMenlo Park, California#368506(RE)

SLAC National Accelerator Laboratory is operated by Stanford University for the Department of Energy. As a management and operating contractor, subcontracts awarded by the Laboratory are not Federal procurements, and are not directly subject to the Federal Acquisition Regulations in 48 CFR. Nonetheless, certain Federal laws, Executive Orders, and regulations may affect our DOE approved purchasing system, as required by statute, regulation, or contract terms and conditions. SLAC National Accelerator Laboratory invites interested vendors to submit a proposal in accordance with the attached RFP preparation requirements for Carbide Laser System with OPA. Your full proposal must be received no later than Tuesday, November 24, 2026, 5pm PST. SLAC has a requirement for a U.S. domestic end item source of the following: Attached RFP_368506(RE)_Carbide_ Laser_System NOTE: The following documents are attached in this solicitation. RFP_368506(RE)_Carbide_ Laser_System.zip Must complete and return all documents mentioned in the cover letter. Please provide required documentation to the attention of Ryan Enos.

On PublicBidSearch: the original bid posting, 1 bid document and the agency contact (name and email) for this bid.

Open Original Bid Source Pro

Contact

Agency contact for this bidName and email — included with ProPro

Overview

Due
Nov 24, 2026
Time stated in bid documents
Nov 24, 2026, 5:00 PM Pacific Time
Submission
email
Documents analyzed
1

Scope of work

  • Supply a complete, factory-tested laser system: femtosecond amplifier, seed oscillator, OPA, chiller(s), control electronics, and software.
  • Install the system at BL17-2 and demonstrate on-site that it meets requirements.
  • Provide at least three (3) days of on-site training for up to two (2) SLAC staff members.
  • Deliver equipment in two shipments: amplifier/OPA first, then seed oscillator.

Steps to Bid

What you'll need

Submission

Email

Pursuit snapshot

Pro
  • Go / no-go verdict on every requirement
  • 10 watch-outs that disqualify bidders
Unlock with Pro — $20/mo

Cancel anytime · no card to browse

Project details

The system includes a diode-pumped, Yb-based femtosecond amplifier, an external seed oscillator with repetition-rate locking electronics, and an optical parametric amplifier (OPA) with a difference-frequency generation (DFG) unit. The scope also includes associated chiller(s), control electronics, and software. The vendor will be responsible for on-site installation and training. The laser system must be synchronized to the SPEAR3 storage ring. Key technical requirements for the femtosecond amplifier include a maximum average output power of 80 W, maximum energy per pulse of 2 mJ, and a pulse duration of < 350 fs. The seed oscillator must have a repetition rate of 79.39 MHz with fine tuning and a pulse duration of < 100 fs. The OPA must have a tuning range of 1400 – 2600 nm (signal) and 2100 – 4200 nm (idler), with the DFG unit extending the range to 4000 – 16000 nm. The system shall comply with U.S. FDA requirements for laser products. Customer support must be available with a response time of < 24 hours. Installation will occur after all equipment has arrived. The contract period of performance is from award through final acceptance. The warranty period is a minimum of twelve (12) months from final acceptance.

Key dates

Bids due
Nov 24, 2026

Documents

  • RFP_368506_28RE_29_Carbide__Laser_System.zip

See all documents · Download with Pro

More from this agency

Closing this week nearby